Fidelity Electronics DM-3000 - Page 42

9.2.1 Label Programing Information Table
Prompt
Command
46
Description
Working
Mode
47
Suggested
Length
K
Date of printing
All
10
L
Time of print
All
8
M
No. of accumulated transaction
Normal
Weighing
7
N
Total accumulated weight
Normal
Weighing
9
O
Net weight
All
10
P
Tare weight
All
10
Q
Gross weight
All
10
R
HI limit
48
Note A
10
S
LO limit
49
Note A
10
T
Comparison Result
All
11
U
Number of piece
Counting
10
V
Average piece weight
Counting
9
W
Reference mass (100%)
Percentage
9
X
Percentage value
Percentage
10
Y
Weight Hold (Animal weighing)
Animal
Weighing
9
Note A: - Good for all except animal weighing mode.
46
Commands must be in capital letter.
47
"All" means the information is good for all working modes.
48
Each working mode has its own Hi Limit format (weight for weighing mode; pieces for
counting mode; % for percentage mode. If Hi Limit has to be printed, set Hi Limit value under
the preferred working mode.
49
Each working mode has its own Lo Limit format (weight for weighing mode; pieces for
counting mode; % for percentage mode. If Hi Limit has to be printed, set Hi Limit value under
the preferred working mode.