— All applicable governmental and local rules, codes, and regulations must be satisfied. This is the
employer’s responsibility.
— All safety-related machine control elements must be designed so that an alarm in the control
logic or failure of the control circuit does not lead to a failure to danger.
— Additional guarding may be required for access to dangerous areas not covered by the pressbrake safety
system AKAS
®
— Perform the Check Daily Procedure (page 9) test procedure at installation and after maintenance,
adjustment, repair or modification to the machine controls, tooling, dies or machine, or the pressbrake safety
system AKAS
®
.
— Perform only the Check Daily Procedure outlined in this manual.
— Follow all procedures in this manual for proper operation of the pressbrake safety system AKAS
®
.
The enforcement of these requirements is beyond the control of Fiessler Elektronik. The employer has the sole
responsibility to follow the preceding requirements and any other procedures, conditions and
requirements specific to his machinery.
Keep the receiver and transmitter optic free of liquid like oil and water!
Keep receiver and transmitter of the AKAS® system clean!
Safety instructions
SI
WARNING! Read and understand this section prior to installing and operating
the system AKAS
®
Please observe always
FIESSLER
E L E K T R O N I K
Doku Nr. 1379 Stand 27.1.2017 / Aui
To Next Page
Loading...