Fiessler AKAS-3PM - Safety Functions and Monitoring

30
KS KE KN
EDMS SGO SP EDMO SGS NLW NA1 NA3NA2 FUS FUO KAST
NC
OSSD1 OSSD2
KX KY
NC
VCC
RXOK1
RXOK2
KRX1 KRX2
M
KNCE KNCE
KY KX
RXD
Umschalt- punkt IN
Ab IN
Eilgangan- forderung IN
NC
Eil OUT Ab OUT
Sicherheitspunkt
TXD
HUSP SGA +24V
KNCE KNCA
SP
KE KS KN KNCE
KE KS KX KY
KNCA wenn KN nicht vorhanden ist
KN
Sicherheits- ventil
Eilgang- ventil
Nachsaug- ventil
Sicherheits- ventil
Eilgang- ventil
Nachsaug- ventil
KRX1 KRX2
Hinteranschläge Antrieb
Presse schließen
KNCA KNCA
rückseitiger Resettaster für das hintere Schutzgitter
Nachlauf- nockenschalter
hinteres Schutzgitter rechtes seitliches Schutzgitter linkes seitliches Schutzgitter Notaus 1 Notaus 2
Eingänge AKAS
Ausgänge AKAS
kann durch die NC oder mit einem Kontakt der Eilgang/Schleichgangumschaltung erfolgen
3-Positions- Fußpedal
Resettaster für Notaus und seitliche Schutzgitter
Kastenbiege- anwahltaster
Schließer von Fußpedal
Eil-/Schleichgang
+24V
+24V
Schlüsselschalter für Justage nur bei AKAS®-LCF
+Ub Sender
Electrical connections - Description / Wiring diagrams
6
-with selectable safety functions
6.4
Doku Nr. 1379 Stand 27.1.2017 /Aui
Wiring example with a suitable hydraulics. AKAS is responsible for all safety related monitoring tasks (at a Hex switch B8 B8 or F8 F8) AKAS monitors both positions of the fast speed and slow speed state and requires: in fast speed: at SGO = + 24 V and at SGS = 0 V
in slow speed: at SGO = 0 V and at SGS = + 24 V During the switching over from one state into the other state, an enhancable switch-over time is tolerated. see selectable switch-over delay enhancement of the valve position monitor
Machine-Safety monitoring by AKAS®-3PF
wiring diagram 2/ p. 30
Sicher- heitsventil
Eilgang- ventil / KE
Nach- saugventil
Stop Eil / Ab
0 1
0 1
0 0
Schleich / Ab Auf
1 0
0 0
1 0
higher switch- over point request IN (only AKAS® 3)
fast speed request IN
safety point
box bending selector switch
3-positions foot pedal
fast out
down out
rear stopper motor
fast speed valve / KE
safety con- tactor / KS
rear protective grid
right lateral protective grid
left lateral protective grid
Emergency OFF 1
Emergency OFF 2
overrun tra- verse cam switch
KNCA if KN is not pre- sent
rear reset button for the rear protective grid
fast / down
slow/ down
up
Press brake
safety valve
fast speed valve
feeder con- tactor / KN
prefill valve
fast / slow speed
AKAS inputs
AKAS outputs
can be carried out by the NC or by a contact of the slow speed/fast speed swiching over
fast speed
valve
feedback
prefill valve
feedback
safety
valve
feedback
close the press
reset button for emer- gency OFF and lateral metal grids
+ Ub transmitter
key switch for ajustment only for AKAS®-LCF
AKAS®-3PF
Picture is only showing half
of a two zylinder hydraulic
FIESSLER
E L E K T R O N I K
normally open con- tact of the foot pedal