Fiessler AKAS-3PM - Functional Descriptions

Description and fields of application for the equipment
Function Description / Characteristics
9
3
3.2
Doku Nr. 1379 Stand 27.1.2017 /Aui
Functions / Characteristics
AKAS®-3PM AKAS®-3PF
with / without Support
self-adjusting onto different tool heights
max. Overrun Traverse of the press brake
with
4 - 11 mm
with
4 - 11 mm
recommended turnover point
from fast speed into slow speed (according to overrun tra-
verse of the press) Distance between metal sheet and
bending punch)
Detecting beams / Receiver elements
Inputs
Overruntraverse control
NLW
0 - 6 mm
3 / 6
-
0 - 6 mm
3 / 6
1 -selectable with / without
3 inputs for control of protection doors / emer-
gency-OFF-circuit NA1, NA2, NA 3 for paired
use
1 pair lateral door circuit, equivalent or antivalent,
1 pair rear door circuit , equivalent or antivalent,
1 pair emergency-OFF-circuit s
Stopp contactor control
EDMO, EDMS
data of traverse in slow speed
SGW
start / stop of closing stroke
FUS, FUO
-
-
-
2 equivalent
position control in slow speed
SGO, SGS
selection of box bending
KAST
safety point
SP
Outputs
1
2 equivalent
1
3 Pairs -selectable with / without
2 -selectable with / without
1 -selectable with / without
2 -selectable antivalent or equivalent switching
1
1
2 -selectable antivalent or equivalent switching
Safety outputs for release of closing stroke
OSSD1, OSSD2
release and Emergency OFF of the rear stoppers
RXOK1, RXOK2
demand of a higher change-over point from fast
speed into slow speed above the slug during
box-bending HUSP
box bending function is displayed
HUSP
2
-
1
1
output for messages RS 232
TXD
demand for slow speed
SGA
1
1
2
2
1
1
1
1
systems without operating mode se-
lection operation only with additional safety
PLC (e.g. FPSC)
systems with operating mode selec-
tion with integrated safety fuunctions
FIESSLER
E L E K T R O N I K
- selectable with / without foot pedal delay