FILL-RITE FR700 - General Description; Safety; Danger Warnings; Safety Instructions

2
Dear Fill-Rite Customer,
Congratulations on your purchase of Fill-Rites new Series
700B pump. We at Fill-Rite have built our worldwide
reputation by designing the finest and most reliable pumps
available in todays market.
Your new pump was designed with pride by some of the best
and most experienced fluid control experts available. We use
the most advanced technology possible to give you a pump
with the superiority you deserve and the quality youve come
to expect from Fill-Rite products.
George P. Jenkins
President
GENERAL DESCRIPTION
SAFETY
The Fill-Rite 700B UL listed pumps are positive displacement,
direct drive pumps. Depending on installation and product
viscosity, these pumps can deliver up to 20 gallons of fluid per
minute. Their rugged, yet lightweight design, makes for a long
life of trouble-free operation.
Fill-Rite 700B pumps safety are proven by their listing with:
Underwriters Laboratories Inc., a nationally recog-
nized independent organization for product test-
ing to ensure public safety. Also recognized in
Canada.
Canadian Standards Association, a Canadian
organization for product testing to ensure public
safety.
Certificates of compliance for safety have been obtained from
Londonderry Occupation Safety Centre and Demko for the
optional models marked with these logos:
To ensure safe and efficient operation, it is essential to
read and follow each of these warnings and
precautions.
1. To prevent damage to pump, do not operate
without the check valve (700F2661) or the check
valvesubstitute (700F2679) in place.
2. Do not smoke near pump or use pump near an open
flame. Fire could result.
3. A filter should be used on pump outlet to ensure that
no foreign material is transferred to fuel tank.
4. Take motors needing service to an authorized
repair shop or return to factory to maintain
explosion proof integrity.
5. The pump motor is equipped with thermal overload
protection. If overheated, it will shut itself off without
any damage to the windings. Be sure to turn off the
pump power if this occurs. As the motor cools, it will
start without warning if power is on.
DANGER
Electrical wiring should be
done by a licensed electrician
in accordance with approved
electrical codes. Pump
should be properly grounded
and a rigid conduit should be
used when installing electri-
cal wiring. Improper use or in-
stallation of this product can
cause serious bodily injury or
death.
SAFETY INSTRUCTIONS