EN
- These installation instructions are an integral part of the product and must be given
to the user. This booklet should be retained for reference.
- Check the condition of the contents after unpacking the filtration unit.
- Before wiring up the unit, make sure the manufacturer’s data is compatible with the
planned system and does not exceed the maximum permitted limits of the particular
item.
- Always cut the electrical power from the main consumer unit before carrying out any
maintenance, handling or repair work.
Any repair work must be carried out by an authorised technical support service using
only OEM spare parts. Failure to comply with the above requirements may cause un-
safe operation of the filtration unit and will void the manufacturer’s warranty.
A high-sensitivity, 30 mA cut-off device must be fitted at the head end.
TERMS AND CONDITIONS OF DELIVERY :
All items, including when sold postage and packing paid, are transported at the
consignee’s risk. The consignee must record any reservations regarding damage in
transit in writing on the CARRIER’S delivery note and provide confirmation thereof
within 48 hours by registered letter sent to the CARRIER.
VOLTAGE: before operating, check that the appliance voltage indicated on the data
plate is the same as the mains voltage (usually 230 Volts AC).
FOREWORD :
Thank you for purchasing this MX 18/25 filtration unit and for your trust in our com-
pany. You can rest assured that every effort has been, and will continue to be made to
bring you complete satisfaction. This product has been carefully designed with your
safety in mind.
Your new filtration unit comes with the same features as a traditional filtration system.
Reminder : a residual current device (maximum 30 mA) must be fitted upstream, and
manually tested, as a safety measure to cut the low-voltage power to pool appliances.
RECOMMENDATIONS
TO PREVENT WATER INGRESS INTO THE NON-WATERTIGHT TANK OF THE MX UNIT
WE ADVISE YOU TO INSTALL A DRAIN ALL AROUND THE POOL THAT RUNS INTO A
RELIEF WELL CONTAINING A BASEMENT SUMP PUMP.
• CLEAN BOTH CARTRIDGES AT REGULAR INTERVALS
• ALWAYS LOCK THE LID SHUT AFTER COMPLETING MAINTENANCE WORK IN
THE TANK
• DO NOT USE FLOCCULANTS OR «MULTIFUNCTIONAL» CHLORINE
1
To Next Page
Loading...
