FILTRINOV MX - Starting the Filtration Unit; Pool-Earth

28
POOLEARTH  FUNCTIONAL EARTH
8
It is vital that the pool be earthed in order to
remove stray currents from the water.
Stray currents are not dangerous to people, but
they do electrolyse the metal components in
the pool, which increases corrosion. They can
also disrupt the treatment probes, resulting in
incorrect amounts of product being injected.
This is why FILTRINOV has included a pool earth
with these products. Screw it into the threaded
attachment point provided and connect it to
the earth rod with a Ø 6 mm copper braid earth
strap (parts not included).
A hole will have to be drilled in the tank to route
the braid through the packing gland provided.
STARTING THE FILTRATION UNIT
7
When the water in your pool is at
of the level of the skimmers, operate the
fi ltration unit for the fi rst time as follows :
1. Prime the pump by fi lling it with water
through the hole provided
2. Screw in the Pool earth
3. Put the fi ltration unit in manual mode to start
the pump
You are strongly advised to unscrew and remove the drain plug from
the tank when you have fi nished installing the fi ltration unit.
Repeat the above steps if the priming procedure is not working
after 2 minutes.