Page 3
After your boom mounts are secured, bolt the 5-nozzle
boom in place with (2) Square U-Bolts and (4)whiz
nuts. (Detail a)
Before tightening the u-bolts in place, center the boom.
With the boom secured to the boom mounts, the nozzle
harness can now be attached. (Detail B)
Attach the nozzle harness to the boom. Starting with the
center nozzle, center the harness on the boom and using
the nozzle clamps, attach the nozzle harness to the boom
as shown in DETAIL Clamp.
DETAIL Clamp
After your nozzle harness is attached to the boom, locate the feeder
hose and the (2) hose clamps.
Place the hose clamps over each end of the hose loosely. Slip the
ends of the hose over the hose barbs on both the manifold (Detail C)
and the ’CROSS’ fitting on the nozzle harness (Detail D). Use a twist-
ing motion, if necessary, to get the hose fully onto each barb. Bring
the hose clamps to the connection point and tighten securely.
Detail C
Detail D
Detail E
Install the pressure gauge (Detail E). Hand
tighten securely.
** DO NOT OVER-TIGHTEN **
Step 5
Assembly Procedure (TR-40-EX)
Step 6
Step 7
Step 8
Detail A
Detail B
To Next Page
Loading...
