10 11
Single Ear Mode
This earbuds supports Single Ear Mode. Once the earbuds are being paired to a device, Single
Ear Mode is automatically activated when only 1 side of the earbuds is on use with another side
being kept inside the charging case.
In this mode, you can hear mixed stereo signals from both
left and right channels even when using only one earbud.
Factory Reset
If Bluetooth pairing is unsuccessful or an unexpected error occurs during low latency wireless
connection, follow these steps to reset the earbuds. After resetting, try pairing or other operations
again:
1. Place both earbuds in a fully charged charging case with the lid open. Press and hold the pairing
button on the charging case for about 10 seconds until the four LED indicators start flashing
rapidly. Release the button once this happens.
2. After the rapid flashing stops, remove the earbuds from the charging case. One of the earbud’s
LED indicators will start flashing alternately in Blue and Red, indicating that it has entered pairing
mode.
* This process completes the reset and returns the earbuds to their factory default state. All
Bluetooth pairing information stored in the earbuds will be erased, so make sure to remove the
pairing information from your smartphone or other device as well, and pair the earbuds again.
* The connection between the earbuds and the Ultra Low Latency USB-C Transceiver will be reset
after performing the factory reset. To reestablish a new connection, please disconnect the
currently connected Transceiver and reconnect it to the gaming device.
Noise Control Mode
3 Noise Control Modes are available, which can also be switched using the dedicated “final
CONNECT” app:
・
Noise-Canceling Mode: Reduces surrounding noise, making it easier to hear playback audio.
・
Ambient Mode: Maintains playback volume while allowing ambient sounds to be heard.
・
Noise Control OFF: Disables both of the above modes.
Factory default setting: Noise-Canceling Mode.
To Next Page
Loading...
