Enviromax System
Operating Procedure
(All outputs)
TO START THE BOILER FOLLOW THIS SEQUENCE:
Turn on fuel supply.
Switch on power supply to boiler.
Turn timer control (If Fitted) to ‘ON’.
Set the boiler thermostat to the required
temperature (figure 1 pg. 5). The boiler thermostat
controls the boiler operation by automatically
maintaining the required boiler water temperature
output. Safe operation is also maintained by the
burner control system which provides the required
ignition and shut off sequence. If a time control is
fitted this will automatically switch the boiler off and
on when heat is required.
THE BOILER C
AN BE TURNED OFF BY
ANY OF THE FOLLOWING MEANS:
Turn the timer control (if fitted) to OFF.
Turn OFF the mains electrical supply to the boiler.
* Lights not included in Utility models.
POPULAR BOILERHOUSE SYSTEM
Enviromax Popular Boilerhouse
Operating Procedure
(All outputs)
TO START THE BOILER FOLLOW THIS SEQUENCE:
Turn on fuel supply.
Switch on power supply to boiler.
Turn timer control (If Fitted) to ‘ON’.
Set the boiler thermostat to the required
temperature (figure 1 pg. 5). The boiler thermostat
controls the boiler operation by automatically
maintaining the required boiler water temperature
output. Safe operation is also maintained by the
burner control system which provides the required
ignition and shut off sequence. If a time control is
fitted this will automatically switch the boiler off and
on when heat is required.
THE BOILER C
AN BE TURNED OFF BY
ANY OF THE FOLLOWING MEANS:
Turn the timer control (if fitted) to OFF.
Turn OFF the mains electrical supply to the boiler.
To Next Page
Loading...
Need help?
General