Firebird Condensing Boiler
1
3
HOMEOWNER INSTRUCTIONS
Utility Operating Procedure
(All outputs)
CONFIRM HEATING SYSTEM IS FILLED
WITH WATER AND VALVES ARE OPEN
TO START THE BOILER FOLLOW THIS SEQUENCE:
Turn on fuel supply.
Switch on power supply to boiler.
Set the boiler operating high limit control aquastat to
the required temperature. The aquastat controls the
burner and circulator operation by automatically
maintaining the required boiler water temperatures
upon a call for heat. Safe operation is also maintained
by the burner control system, which provides the
required ignition and shut off sequence.
Turn on room thermostat.
THE BOILER C
AN BE TURNED OFF BY ANY OF THE
FOLLOWING MEANS:
Turn the switch to OFF
(mounted on side of boiler).
Turn OFF the main emergency switch to the boiler
(usually at the top of the cellar stairs).
Always keep the oil supply valve closed if the
burner is shutdown for and extended time.
Note: Burner ignition is delayed until oil
line heater is satisfied ( 1 to 2 min)
POPULAR BOILER UTILITY BOILER
Popular Operating Procedure
(All outputs)
CONFIRM HEATING SYSTEM IS FILLED
WITH WATER AND VALVES ARE OPEN
TO START THE BOILER FOLLOW THIS SEQUENCE:
Turn on fuel supply.
Switch on power supply to boiler.
Set the boiler operating high limit control aquastat to
the required temperature. The aquastat controls the
burner and circulator operation by automatically
maintaining the required boiler water temperatures
upon a call for heat. Safe operation is also maintained
by the burner control system, which provides the
required ignition and shut off sequence.
Turn on room thermostat.
THE BOILER C
AN BE TURNED OFF BY ANY OF THE
FOLLOWING MEANS:
Turn the burner switch to OFF
(mounted on side of boiler).
Turn OFF the main emergency switch to the boiler
(usually at the top of the cellar stairs).
Always keep the oil supply valve closed if the
burner is shutdown for and extended time.
Note: Burner ignition is delayed until oil
line heater is satisfied ( 1 to 2 min)