Fireco Deafgard - Trouble Shooting; Common Issues and Solutions

Trouble Shooting
The following are the most frequently
asked questions regarding the Deafgard
unit, with a quick checklist to follow:
1. Why does Deafgard not react to
your fire alarm?
• Check fire alarm is louder than 75dB.
• Check batteries.
• Check fire alarm is sounding for at
least 30 seconds.
• Adjust sensitivity of the Deafgard
unit.
2. Why does the Pillow Pad not
vibrate?
• Check Power is On.
• Check batteries.
• Check cable from Pillow Pad is
connected securely to the Deafgard
unit.
• Check Pillow Pad is not in the cradle.
3. Why do Strobe LEDs not flash?
• Check Power is On.
• Check batteries.
• Check cable from Pillow Pad is
connected securely to the Deafgard
unit.
4. Why is there no display on the
LCD?
• Check Power is On.
• Check batteries.
If all the above points are satisfied
and further assistance is required
please contact the Technical
Advice line.
Note: Deafgard will
display error messages on
the LCD if a fault occurs. If
this happens perform a
reset on the unit by
removing and re-inserting
of all batteries. If error
remains contact the
Technical Advice line.
16