7
Getting Started
1. Ensure the Pillow Pad Cable has not
been disconnected from the Base.
Note: The Pillow Pad should
remain in the cradle.
2. Unscrew the Front battery Cover: pull
the Cover away from the Base until
you feel resistance.
Note: The battery orientation
diagram on the inside.
3. Insert two batteries with both
Positive (+) ends facing out towards
Battery Closer.
Note: The correct orientation is
important.
4. Screw the Battery Closer closed.
Note: To not over-tighten.
a. The clock will be displayed.
b. Both Strobes should have flashed
twice.
c. A ‘bleep’ should have been heard
once.
d. The LED should be flashing RED
once every 7 seconds.
To Next Page
Loading...