The ES18B is also identified as FK1 and is referred to FK1 in this document.
2.1
Opening the Lock and
Accessing Menu
The safe lock system has default code installed
as follows:
Manager Code (ID01) 123456
STEP 1:
When the screen is off, Pressing the up and
down select and return keys is invalid.
STEP 2:
Enter the
6-8 digit code
and Press “Menu/
OK” key and the Lock will open. The display will read:
The lock will relock after 3.5 seconds.
Note 1: Time to relock is hard coded and cannot be
changed. During unlocking period 2, the following
will be displayed:
At this point, use the up and down keys to browse
the menu, Press “Menu/OK” key into the following
2.2
~ 2.13
permissions.
Note 2: When the cable is not connected with the lock
body, the following will be displayed:
The LCD will display “invalid code” when the input
password is wrong, then return to the standby state after
2 seconds. When the wrong password is input more
than 4 times, the system locks for 4 minutes and display
will flash every 15 seconds. Countdown starts and the
following will be displayed:
2.2
Encryption Key Set
The FK1 sends and receives data to the lock in an
encrypted form. This is a security measure to ensure that all
data is protected. The Encryption Key is set during
the manufacturing process with a default encryption key
value. This value can be changed using the Encryption
Key Set menu selection.
Note: If the Encryption Key is changed from the default
setting, this value must be maintained, as it is a vital
element to communicate with the lock inside the safe.
STEP 1:
Enter a valid code
STEP 2:
Using the
▲
or
▼
scroll to the “Encryption Key
Set” and Press “Menu/OK.”
STEP 3:
Display will read “Enter Code.” Enter existing
Encryption Key (60612000). Press “Menu/OK.”
To Next Page
Loading...