In which:
80 °C = set product temperature
25 °C = temperature actually measured by the core probe
150 °C = set base temperature
25 °C = temperature actually measured by the base probe
Confirm by pressing
, then it will be necessary to confirm if we wish to start holding
cycle (65 °C) until the end of the cooking cycle.
If you select “YES”:
once the set product temperature has been reached, the appliance will stop heating and
start a holding cycle at 65 °C for an infinite time (shown on the display with 0).
Press
S T A R T
S T O P
to interrupt the holding cycle.
If you select “NO”:
once the set product temperature has been reached, the appliance will stop heating and
not carry out any holding cycle.
6.1.1. How to select cooking time with C-N probe
This type of cooking is related to temperature and not to time, however it is possible to set
a cooking time that will start countdown from the moment in which the selected product
temperature has been reached.
In this case, press
select desired time using
and confirm by pressing
Example:
Product temperature 85°C
Bottom temperature 120°C
Cooking time 60 minutes
Holding = YES
During the heating cycle, the selected time appears only if the core temperature is
reached. Press
to view it for at least 20 sec.
Once the temperature of 85°C has been reached, it is
held for 60 minutes. Once the time is over, heating
stops and starts off again only to hold food at a
temperature of +65°C.
To Next Page
Loading...
Need help?
General
