Why does my Firman P03603 Portable Generator engine “hunt” or falter?
If the engine on your Firman Portable Generator “hunts” or falters, the fuel filter may be clogged or dirty. Try cleaning or replacing the fuel filter.
What to do if Firman Portable Generator remote start system is not working?
If the remote start system of your Firman Portable Generator is not working, first replace the batteries in the remote control. If that doesn't work, move closer to the generator, ensuring you are within 164 feet. If it still doesn't work, you may need to program the remote control to the generator.
What to do if my Firman Portable Generator won't start?
If your Firman Portable Generator won't start, consider these potential causes: * The engine switch may be in the OFF (O) position. If so, set it to the ON (l) position. * The fuel shutoff lever might be in the OFF (O) position; move it to the ON (l) position. * The oil level could be low. Refill the crankcase to the correct level or place the generator on a level surface. * The air cleaner may be dirty. Clean or replace it. * The generator might be out of fuel; refill the fuel tank. * The fuel could be stale. Drain the fuel tank and carburetor, then refill with fresh fuel. * The spark plug wire might not be connected. Connect it to the spark plug. * The spark plug may be bad. Replace the spark plug. * There may be water in the fuel. Drain the gas tank and carburetor, th...
Detailed explanation of the generator's control panel and its indicators.
Procedures for adding engine oil and understanding the low oil shutdown feature.
Instructions for adding fuel and considerations for operating at high altitudes.
Proper placement of the generator and advice on protecting connected electronics.
Guidance on maintaining the generator's engine, including oil and air filter.
Details on warranty coverage, terms, exclusions, and return policy.
General| Type | Portable Generator |
|---|---|
| Running Wattage | 3300 Watts |
| Fuel Type | Gasoline |
| Engine Type | 4-Stroke |
| Engine Displacement | 208 cc |
| Starting System | Recoil |
| Run Time | 12 Hours at 50% Load |
| DC Output | 12V 8A |
| Noise Level | 68 dBA |
| Outlets | 2 x 120V AC |
To Next Page
