A) HAY CUATRO FORMAS DE DAR ENERGÍA A LA UNIDAD
1) Operación con ENERGÍA DE "DÍNAMO"
unidad por primera vez, abra el compartimiento de la batería, e inserte
la batería recargable según el diagrama de polaridad dentro del
compartimiento.
1.El FA1160 incluye una batería recargable 3.7V DC de litio. Al usar la
2.Cierre la Puerta de la Batería.
3.Configure el Selector de Fuente de Energía en la posición de la "Batería Li-ion" .
4
totalmente extendida. Gire la manivela hacia la derecha como se
muestra a continuación. Se iluminará el indicador de "CARGA".
.Levante la Manivela de Arranque hacia afuera hasta que ésta esté
Li-ion
Manivela de arranque
5
batería. Mientras más gire la manivela de arranque, más energía estará
generando, y podrá escuchar la radio por más tiempo
(solamente recepción de radio).
.Continúe girando la manivela hasta generar electricidad para cargar la
Nota: Si la batería está totalmente agotada podría requerir que haga girar la
manivela hasta 5 - 6 minutos, mientras tanto no funcionará la pantalla LCD del
reloj. Puede que necesite pulsar el botón reset si se carga la batería de litio
hasta por arrancar pero radio o luz LED no funciona.
6.Oprima el botón de Encendido/En espera para encender al unidad.
No queme ni entierre las baterías. No las perfore ni las triture. No
intente desarmarlas. Recicle las baterías de litio. No las deseche
entre la basura.
En caso de que el electrolito entre en contacto con su piel, lávese perfectamente
con agua y jabón. Si llegara a entrar en contacto con los ojos, lávese perfectamente
con agua fría. Consulte de inmediato al médico.
Instrucciones de Seguridad de la Batería de Litio
Utilice solo cargadores para baterías de litio. Asegúrese de que el voltaje
del cargador y de la configuración sea correcto para el paquete de baterías
que se está cargando.
Cargue las baterías sobre una superficie a prueba de incendios, lejos de
artículos o líquidos inflamables.
6
A) FOUR WAYS TO POWER THE UNIT
1) “DYNAMO” POWER OPERATION
first time using the unit, open the battery compartment and insert the
rechargeable battery according to the polarity shows inside the compartment.
1.A 3.7V DC rechargeable lithium battery is included with FA1160. When
2.Close the Battery Door.
3.Set the Power Source Selector to the “Li-ion Battery” position .
4
Crank clockwise as shown below. The CHARGING Indicator will light.
.Lift the Crank Handle outward until it is fully extended. Rotate the
Li-ion
Hand Crank
5
More power is generated the longer you turn the crank handle, and the
Radio listening time will be extended (Radio reception only).
.Continue turning the Crank to generate electricity to charge the battery.
Note: It may require up to 5 - 6 minutes of cranking if the battery is completely
drained and the LCD clock display and LED light do not work. You may need to
press the reset button if lithium battery is charged up by cranking but radio or
LED light does not work.
6.Press the Power On/Standby button to turn on the unit for operation.
Do not burn or bury batteries. Do not puncture or crush. Do not
disassemble. Recycle Lithium batteries. Do not dispose of in the
trash.
If the electrolyte in the cells should get on your skin, thoroughly wash with
soap and water. If in the eyes, rinse thoroughly with cool water.
Immediately seek medical attention.
Use only chargers rated for Lithium cells. Be sure the charger's voltage and
current settings are correct for the battery pack being charged.
Charge batteries on a fireproof surface away from flammable items or liquids.
Lithium Battery Safety Instructions
Batteries should NEVER be left unattended while charging. Only adults
should charge the batteries.
Follow the manufacturer's instructions for charging the product and do not
charge longer than recommended. Unplug the charger when the battery is
charged.
6