https://
install.myfirstech.com
Copyright 2020 Fi rste ch, LLC. “Hello, my name is Inigo Montoya....” Page
49
3-09 Siren output: This feature controls the siren (+) output behavior during Arm, Disarm, and Remote
Start.
FO1 - On lock, Unlock, and Start: (default) this option will provide a (+) siren output pulse (based
on the option selection of feature 3-02) with each lock, unlock, remote start command and remote
started confirmation.
FO2 - On double lock only: This option is designed to simulate a factory keyless entry system by
providing a (+) siren output pulse (based on the option selection of feature 3-02) each time the lock
command is sent a second time within 8 seconds of the first lock command.
FO3 - On lock and Unlock only: this option will provide a (+) siren output pulse (based on the option
selection of feature 3-02) with each lock or unlock confirmation.
FO4 - On double lock and Start: this option is designed to simulate a factory keyless entry system by
providing a (+) siren output pulse (based on the option selection of feature 3-02) each time the lock
command is sent a second time within 8 seconds of the first. In addition, it will provide a (+) siren output
pulse with remote start command and remote started confirmation.
3-10 Valet Mode: This feature will change the enter/exit valet mode procedure based on the option
selected.
FO1 - Key 5 times with Foot Brake Trigger or Remote (Lock + Trunk) while Ignition is on: This
option allows the user to enter valet mode using either method described. Note: the user may exit valet
mode with their Firstech remote (please check users guide for each remote for valet mode exit
procedure), or with the key to ignition or “on” position and press the foot brake 10 times within 10
seconds.
FO2 - Key 5 times with Foot Brake Trigger or Remote (Lock + Trunk): This option allows the user to
enter valet mode using either method described. Note: the user may exit valet mode with their Firstech
remote (please check users guide for each remote for valet mode exit procedure), or with the key to
ignition or “on” position and press the foot brake 10 times within 10 seconds.
FO3 – (-)NEG Valet Input: This option will allow a (-)PIC set to 22 “Valet Input” to be used as a wired
Valet mode enter/exit option. When this option is selected the previous Valet enter/exit options will no longer
work, except when using Drone Mobile.
This input will require (-)NEG input for 5 seconds minimum, followed by 5 (-)NEG input pulses to
enter/exit Valet mode.
Any PIC set to Valet Input can be connected to a momentary or latching toggle switch mounted somewhere in
the vehicle. NOTE: When using this option for security purposes, make sure the switch is mounted in a
discreet location, but it also must be accessible to the user.
3-11 Auxiliary 3-7 Enable: (2 Way LCD remote required) this feature enables access to AUX 3 through 7
via any Firstech 2-way LCD remote.
FO1 - Off: (Default) This option will prevent the user form activating AUX 3-7 with the Firstech 2way
LCD remote.
FO2 - On: This feature will allow the user to enable AUX 3-7 which can be activated using a Firstech
2-way LCD remote. (Please refer to the remote users guide for specific AUX 3-7 activation process)
To Next Page
Loading...