https://
install.myfirstech.com
Copyright 2020 Fi rste ch, LLC. “Hello, my name is Inigo Montoya....” Page
62
SV 33 – Secure Start N/C: Provides a 250mA timed output that can be used to manage an FTI-SPTS
vehicle PTS button disable harness. It will output at the exact moment an alarm event is triggered
and remain active based on the time selected using feature 3-18. While disarmed, there will be no
output so the vehicle PTS button will function normally. (PTS Starter kill)
Special Options Group 3: This special option group allows you to select the input settings of the
Programmable Input Channel (PIC) wire. i.e. If you want to set PIC #5 (default setting (-) hood status
INPUT) to (N/C) hood pin INPUT, you will need change special option 4 from 0 to number 11 using your
OP500 or flashing website.
PIC 1 - Light Blue: (-) E-Brake INPUT (Emergency/parking brake input) (default setting)
(function also PIC setting 1)
PIC 2 - Violet/Black: (-) Trunk Status INPUT (Trunk input) (default setting) (function also PIC
setting 2)
PIC 3 - Brown/White: (-) Key Sense INPUT (default setting) (function also PIC setting 3)
PIC 4 - Red/White: (-) Door INPUT (default setting) (function also PIC setting 5)
PIC 5 - Gray/Black: (-) Hood Status INPUT (default setting) (function also PIC setting 4)
PIC 6 - AUX INPUT 1 Green Connector pin 4: (-) Prewarn Input (default setting) (function also PIC
setting 13.)
PIC 7 - AUX INPUT 2 Green Connector pin 2: (-) Instant Trigger Input (default setting) (function also
PIC setting 14)
PIC setting value description (SV)
SV 1 - (-) E-Brake INPUT: This setting allows any PIC programmed with value 1 to be used as a (-)
negative parking /emergency brake INPUT.
SV 2 - (-) Trunk Status INPUT: This setting allows any PIC programmed with value 2 to be used
as a (-) negative Trunk status INPUT. This can be used as a single trunk or multi rear door input
for security or Manual transmission remote start.
SV 3 - (-) Key-Sense INPUT: This setting allows any PIC programmed with value 3 to be used as a (-)
negative Key-sense INPUT. Keysense is recommended when using the RFID Unlock feature,
remote starting manual transmission vehicle, or when using passive arming mode with security
SV 4 - (-) Hood Status INPUT: This setting allows any PIC programmed with value 4 to be used as a (-)
negative Hood Status INPUT. This can be used as a single hood pin input for security or Manual
transmission remote start.
SV 5 - (-) Door Status INPUT: This setting allows any PIC programed with value 5 to be used as (-)
negative Door Status. This can be used as a single door or multi door input for security or
Manual transmission remote start. It is also recommended when using the RFID Unlock feature,
or Turbo timer mode.
To Next Page
Loading...