.
Remote Start Shutdown Error Codes
If the remote start sequence has been completed and the vehicle shuts down, the vehicle’s parking lights
will flash 4 times, pause then flash again with the error code. Tap button 4 on 2 Way remotes to initiate
the shutdown error codes. On 1 Way remotes hold the Trunk and Start buttons together for 2.5 seconds.
Number of
Parking Light
Flashes
Remote Start Shutdown Error
Lost engine sensing signal (Tach/Alternator/Tachless)
Lost emergency brake signal (Manual Transmission)
Remote Start Reservation Mode Diagnostic Codes
If the remote start sequence has been completed and the vehicle shuts down, the vehicle’s parking
lights will flash 4 times, pause then flash again with the error code. After reservation mode failure,
tap the Start button on 2 Way remotes for ½ second to initiate the shutdown error codes. On 1 Way
remotes hold the Trunk and Start buttons together for 2.5 seconds.
Number of
Parking Light
Flashes
Reservation Mode Diagnostics
Tach has been lost or interrupted while reservation mode was
setting. Tach is present after reservation mode completed.
E-brake signal has been lost before or after reservation mode
completed
Foot Brake was triggered before or after reservation mode
completed
Hood input was triggered before or after reservation mode
completed
Door Input was triggered before or after reservation mode
completed
Trunk input was triggered before or after reservation mode
completed
Security has been triggered after reservation mode completed
Ignition input detected after reservation mode completed
Keysense Input detected after reservation mode completed