EasyManuals Logo

Fischer Panda Panda 4000s.Neo PMS User Manual

Fischer Panda Panda 4000s.Neo PMS
94 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #73 background imageLoading...
Page #73 background image
Maintenance Instructions
23.3.18 Kapitel/Chapter 6: Maintenance Instructions - Seite/Page 73
Open the generator casing.
Screw the oil dipstick out of the check rail.
• Clean oil dipstick.
Fig. 6.7-1: Oil dipstick Put the oil dipstick back into the check rail, do not screw it in
and wait for 10 seconds.
Pull the oil dipstick out of the check rail and read off the oil-level at the lower end of the stick.
Fig. 6.7-2: Oil dipstickOil dipstick FP320 Engine
The oil-level is to be checked by means of the oil dipstick.
The prescribed filling level must not cross the „Max“-mark.
We recommend an oil-level of 90%.
Oil should be refilled, if the oil-level is under 50 % between the minimum and the maximum mark.
Fischer Panda recommends an oil-level of 90 % between the minimum and the maximum mark.
If the oil-level is under the MIN-mark, check how many operating hours went by since the last oil change, by means
of your service manual or an existing oil change tag. - with operating hours between 50 and 150 hours it is only
necessary to refill oil. See section 6.7.1, “Refilling oil,” on page 73.
with 150 operating hours or more the oil should be changed (See your generators’ service table)
if the oil-level is under the minimum mark by less than 50 h, there might be a technical problem! In that case, we
recommend going to a shop or a Fischer Panda service point.
if the oil is cloudy or even „creamy“, coolant might have mixed with the oil. See a garage or a Fischer Panda service
point immediately.
6.7.1 Refilling oil
You require:
Engine oil
1. Check oil-level as described under section 6.7, “Checking oil-level,” on page 72.
2. Oil dipstick is pulled out of the check rail.
3. Open the oil filler cap.
4. Fill in oil (approx. 0,1 litre) and wait for about 2 min. so this it can flow into the oil pan.
Oil Max.
Oil Min.
90% Suggestion

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fischer Panda Panda 4000s.Neo PMS and is the answer not in the manual?

Fischer Panda Panda 4000s.Neo PMS Specifications

General IconGeneral
Voltage230 V
ProtectionIP23
Frequency50 Hz
Phase1-Phase
Input Voltage12 V

Related product manuals