Installation instructions
Unpacking
To ensure the best performance from your new CleanSmart™ clothes washer please follow the instructions below.
Removing the packaging
1. Remove the outer packaging.
2. Tilt the machine backwards and walk it off the base
packer one foot at a time (ensure the lid is still taped
down).
3. Remove the base packer from under the machine by
pulling it out the front.
4. Remove the tape, lift the lid and remove the bowl
packer from the bowl.
5. Remove the hoses and accessories.
6. Keep the base packer and bowl packer in case they are
required for future transit.
Fig. 1 Tilt washer backwards to remove
packer
Ensure that the bottom packer has been removed BEFORE OPERATING your machine.
Location
Your washer must be installed on a level surface, not on any textured floor coverings (eg carpet, rugs) to ensure the
opening at the bottom of the machine is not obstructed.
https://producthelp.fisherpaykel.com/nz/Wash/Top_Loaders/CleanSmart/WL1068P1/User_Guide_WL1068P1/02_Installation_…
Updated: Sat, 16 Nov 2019 03:22:08 GMT
Powered by
1
To Next Page
Need help?
General
