EasyManua.ls Logo

Fisher & Paykel DCS CDU Series - Power Requirements

Fisher & Paykel DCS CDU Series
44 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12
INSTALLATION INSTRUCTIONS
US
CA
COUNTER TOP
GAS SUPPLY
Installer supplied
shut-o valve must
be easily accessible
inside cabinetry
ELECTRIC SUPPLY
4 FOOT POWER CORD
COUNTER TOP
GAS SUPPLY
Installer supplied
shut-o valve must
be easily accessible
inside cabinetry
ELECTRIC SUPPLY
4 FOOT POWER CORD
90
0
Elbow
supplied*
(CDU-304
only)
• Required when unit is installed over Wall Oven
REGULATOR
REGULATOR
GAS CONNECTION FOR CDU-365
GAS CONNECTION FOR CDU-304
POWER REQUIREMENTS:
120 VAC, 60 Hz., single phase.
CDU-304/CDU-365: 0.10 Amp. Max.
(Use 15 Amp. circuit minimum)
Always disconnect the electric supply cord from the wall outlet or turn off the electricity at the service disconnect
before servicing this appliance.
Observe all governing codes and ordinances when grounding, in the absence of which, observe National Electrical
Code ANSI/NFPA No. 70-1990.
Wiring diagrams are included in the service summary, attached to the bottom of the cooktop chassis.
The rating label is located on the bottom of the cooktop chassis, towards the front on the right-hand side.
Top view
FRONT
Chassis
Rating label

Related product manuals