17
IGNITION OF THE BROIL BURNER
IMPORTANT NOTE: the fan motor cannot be used in combination with the broil
burner. A safety device switches off the fan motor when the gas oven/broil con-
trol knob is turned on BROIL position.
The broil burner generates the infra-red rays for broiling.
To light the broil burner operate as follow:
1) Open the oven door to the full extent.
WARNING: Risk of explosion!
The oven door must be open during this
operation.
2)
Lightly press and turn the thermostat knob clockwise to the
BROIL
position.
3) Press the knob right down to prime the electric ignition. Keep the knob
pressed.
In case of power cut, press the knob and put a lighted match to the right and
left side of the burner (fig. 3.6).
Never continue this operation for more than 15 seconds. If the burner has still
not ignited, wait for about 1 minute prior to repeating the ignition.
4) Wait about 10/15 seconds after the burner lighting before releasing the knob (time
of priming of the valve).
5) Close the oven door slowly.
If the flame extinguishes for any reason, the safety valve will automatically shut off the
gas supply to the burner.
To re-light the burner, first turn the oven control knob to position OFF, wait for at
least 1 minute and then repeat the lighting procedure.
c
Do always broil with oven door closed.
Attention: the oven door becomes very hot during operation.
Keep children away.
Fig. 3.6
Fig. 3.5
3
To Next Page
Loading...
Need help?
General
