(OFF) position.
Flame failure safety feature
The flame failure probe cuts off the gas supply to the burner if the flame is blown out.
When lighting the burner, hold down the dial for approximately 10 seconds after the burner has lit. Releasing the
dial too soon will extinguish the flame.
If the flames are accidentally extinguished, turn off the burner and do not try to light it again for at least one
minute (to allow the gas to disperse).
If a burner does not light
Check that:
▪ The cooker is plugged in and the electricity is switched on.
▪ The gas is turned on.
▪ The gas bottle is not empty (if you are using bottled gas).
▪ You have held down the dial for at least 10 seconds.
▪ The ignitors are sparking. If the ignitors are not sparking, they may be dirty or wet. Clean them with a toothbrush
and methylated spirits, as shown in Fig.26.
Fig. 26 Cleaning the probe and ignitor
If the flame is irregular
If the flame is yellow or irregular, check that the burner parts, including the burner cap, are:
https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Dual_Fuel/OR90SDBGFPX1/User_Guide_OR90SDBGF…
Updated: Wed, 12 Apr 2023 03:12:03 GMT
Powered by
5
To Next Page
Loading...
