Fisher & Paykel QuickSmart - Before You Do Your First Wash

11
BEFORE YOU DO YOUR FIRST WASH
You owe it to yourself and your washer to have your washer installed correctly.
Before you start, it is a good idea to go through the following checklist:
1
Has the base packer been removed? Refer to page 6.
2
Is the drain hose threaded through the ‘U bend’ (with no more than 20mm extended)
and hooked into your tub or standpipe? Refer to page 6.
3
Is the hot hose connected to the Hot valve marked ‘H’? Is the cold hose connected to
the Cold valve marked ‘C’? Refer to page 8.
4
Is the washer correctly levelled, feet are extended and cabinet corners are clear of the
floor? Refer to page 9.
5
Have you performed the installation test cycle? Refer to page 10.
WashSmart™ washer and QuickSmart™ washer capacities
The table below outlines what is included in a 7kg, 7.5kg, 8kg and 8.5 kg wash load
(in accordance with AS/NZS2040.1:2005).
WASH LOAD 7kg 7.5kg 8kg 8.5kg
Sheets (double) 2 3 3 3
Bath towels 6 4 4 5
Tablecloths 2 2 3 3
Shirts 3 4 5 5
T-Shirts 4 5 5 5
Pillowcases 4 4 5 6
Shorts 7 6 5 6
Washcloths 6 8 8 6
Handkerchiefs 4 8 6 8
Note: the above load composition is indicative only. We recommend for everyday
use that you separate out your sheets and towels and wash them separately on the
‘Regular’ cycle.
Note: the WA1060E model has a different capacity based on country standards. Refer
to the serial plate on the back of the product.