INSTALLATION
INSTALL.ATION
INSTALLING
To ensure the best performance from your new
1.
Uncoil power cord.
Smart Drive please read the following
instructions carefu IIy.
-.
2~
Remove the
blaCK
ribbed drain hose from
the fixture on the left hand side of the rear
UNPACKING
panel
by
carefully pulling the exposed part -
1.
Having removed the outer packaging, leave
l.
of the hose downwards and outwards.
the
machine standing upright in the bottom
-cardboard packer.
3.
Connect drain hose to tub or standpipe. The
hose guide, included in the accessory kit, is
2.
Lift.
lid and remove bowl packer from bowl..
to
guide the drain hose over the
tub'or
sta-ndpipe. It MUST be fitted to the drain
hose. The-drain hose should not extend
3.
Remove hoses and
accesso.r-ies.
4.
Rotate
the
agitator anti-clockwise
for
3
more than 20mm from the end
oHhe
guide
revplutions to unscrew the transit restraint.
(this
is
to
prevent sypho'ning). If
nece_ssary
(The wash bowl
will
then
be
free
to
move
the drain
ho~e
can
be
trimmed to le-ngth.
from
side to side.)
4.
Place
filtered sealingwashers (from
-5.
Flatten the bottom cardboard packer,
accessory kit) into straight end of the plastic
remove machine checking the transit
inlet hoses and connect
to
taps.
restrainthas come away with the cardboard
packer. Keep the transit restraint and bowl
5.
Place
sealing washers (from accesso:ry kit)
packer in
case
they
are
required
for
ftlture -
,
into the elbow ends
of
plastic inlet hoses
transit. -
FILTERED
and connect
to
machine inlet valves. -
SEALING
Inlet valves
are
marked on the .rear of
WASHER
~
machine.
H hot C
= cold
PLEASE
ENSURE
THE
TRANSIT RESTRAINT
Turn on water and
.check
hose connections
HAS
BEEN
REMOVED
BEFORE
OPERATING
TAP END
YOUR
MACHINE.
for leaks.
6.
Move the machine into its final position.
(We suggest a
minimum
clearance of 20mm
either side
of
the machine
for
ease
of
SEALING
WASHE.R
installation.)
Make sure there are no kinks
inthe
hoses.
7.
It
is
IMPORTANT
to
level the machine.
Fit the rubber inserts into the feet on
the
base of the machine. Adjust the feet
to
make sure the machine
is
level.
MACHINE
1:)
(RefE1r
to page
5.)
END
8.
Make sure the machine is firm
on
all
levelling feet.
9.
Plug power cord into wall socket.
BOTTOM •
CARDBOARD PACKER
3
2
ROTATE ANTI-CLOCKWI'SE
To Next Page
Loading...
