Need help?Do you have a question about the Fisher CZ-7a PRO Quicksilver and is the answer not in the manual?
General| Weight | 2.5 lbs (1.13 kg) |
|---|---|
| Discrimination | Yes |
| Sensitivity | Adjustable |
| Ground Balance | Automatic |
| Target ID | Yes |
| Pinpoint Mode | Yes |
| Battery Life | 20-25 hours |
| Type | VLF |
| Audio Output | Speaker and headphone |
| Battery | 9V |
| Waterproof | No |
| Search Coil | Concentric |
| Battery Type | 9V alkaline |
| Search Coil Size | 8' (20 cm) |
How the detector visually identifies targets and its LCD display features.
How to selectively ignore or accept different target classifications.
Detector's ability to differentiate between similar targets.
Explains different methods for adjusting ground balance.
Features for determining target depth and amplifying faint signals.
Details on the detector's splashproof, rainproof, and dustproof qualities.
Information on balance, comfort, and three-piece breakdown.
Unpacking the detector and assembling the main stem components.
Steps for adjusting the stem length and search coil angle for optimal use.
Instructions for wrapping and securing the search coil cable along the stem.
Reconnecting the coil cable and confirming the correct search posture.
Detailed steps for attaching the control housing to a belt loop or harness.
Guide to using the detector's factory preset "coins-only" mode.
Steps for starting a search and adjusting audio volume for optimal listening.
Explanation of the main knob for power and ground balancing.
How to use the light function and adjust audio volume via touch pads.
Selecting between normal and salt modes, and autotune vs. target ID.
Adjusting sensitivity and using the factory preset control settings.
How to accept or reject specific target categories using the notch feature.
Using arrow pads for adjustments and the search/pinpoint function.
Using the search/pinpoint pad for target location and depth estimation.
Recommended control settings for turning on the detector for the first time.
How ground mineralization affects detector signals and the need for balancing.
Step-by-step guide to performing ground balance using the pushbutton method.
Detailed instructions for the bobbing method of ground balancing.
Explains the Autotune mode and its uses in non-trashy or mineralized areas.
How to use the Target ID mode for identifying various targets and its audio responses.
Examples of using notch settings for specific hunting goals like gold or coins.
Guidance on walking speed, overlap, and coil parallelism for effective searching.
How sweep speed, ground mineralization, and search mode affect target detection depth.
Using the search/pinpoint pad for quick target location and approximate depth reading.
Key rules to follow for successful target identification with the CZ-7a Pro.
Practical steps to perform accurate target identification after pinpointing.
Guidance on recovering targets neatly and the tools used for digging.
Explains frequent causes like trash, deep targets, and electrical interference.
How to handle signals from wet sand, hot rocks, and targets that aren't there.
Advice on sweep patterns and reducing masking effects in trashy areas.
Guidance on setting sensitivity levels and adjusting notch settings carefully.
Tips on verifying targets, digging suspicious sounds, and practicing operations.
Steps for removing and installing the 9-volt batteries correctly.
Instructions for keeping the detector clean, dry, and protected from damage.
Details on the detector's operating modes, frequency, and ground adjust.
Information on the search coil type, diameter, and weather resistance features.
Specifications for weight, audio output, target response, and physical dimensions.
Information on Fisher's history, quality, and lifetime warranty.
Contact details for customer service and export department.
To Next Page