BATTERY REPLACEMENT
Three battery markers showing on the LCD indicate fully
charged, or nearly fully charged batteries. Two markers mean
that the batteries have been used for several hours but are still
well within operating range. One or no markers mean that it's
time for new batteries. Two 9-volt transistor batteries are
located in separate compartments on the underside of the
control housing.
1. Remove the control housing from the
handle grip by holding the grip in one
hand and sliding the control housing
toward you.
2. Remove the battery doors by gently lifting the
two tabs at the end of the control housing.
3. Remove the batteries by pulling on the nylon
straps attached to the bottom of the battery
compartments.
4. Install fresh alkaline batteries and reinstall the
battery covers. Make sure the batteries are
positioned properly as indicated by the "+"
polarity markings inside the battery
compartments.
If either or both of the batteries are installed
incorrectly, the CZ-7a Pro will simply not turn on.
The detector will not be damaged.
LOW OK BATTERY
42
To Next Page
Loading...
