Instruction Manual
D103557X012
Field Communicator Menu Trees
April 2016
85
Appendix B Field Communicator Menu Trees
This section contains the DVC6200 SIS Field Communicator menu trees. It also contains an alphabetized
function/variable list to help locate the function/variable on the appropriate menu tree. All Fast Key Sequences
referenced in the menu trees assume the Online menu (see figure B-2) as the starting point.
Function/Variable List
Function/Variable
See Figure
Action on Failed Test B-7
Actual Travel B-5
Actuator Manufacturer B-5
Actuator Model B-5
Actuator Selection B-5
Actuator Size B-5
Actuator Style B-7
Air B-5
Alert Record Full Enable B-8
Alert Record Not Empty Enable B-8
Alert Switch Source B-7
Analog Input B-3, B-10
Analog Input (Calibration) B-9
Analog Input Units B-5
Area Units B-5
Auto Calibration B-9
Auto Test Interval B-7
Auxiliary Terminal Action B-5
Auxiliary Terminal Action, Edit B-5
Breakout Torque B-5
Burst Mode B-7
Calibration Button B-5
Calibration Record B-9
Calibration Time B-9
Calibration Type B-9
Calibrator B-9
Change Device Powerup B-7
Change Instrument Mode B-1, B-5
Change to HART 5 B-10
Change to HART 7 B-10
Change Write Protection B-1, B-3, B-5
Clear Records B-8, B-10
Critical NVM Failure Shutdown B-8
Custom Characterization B-6, B-10
Cycle Count Alert Enable B-8
Cycle Count Alert Point B-8
Cycle Counter B-10
Cycle Count/Travel Accum Deadband B-8
Days Powered Up B-10
DD Information B-3
Description B-3, B-5
Device ID B-3
Device Revision B-3
Device Setup B-4
Device Status B-3, B-10
Function/Variable
See Figure
Drive Current Failure Shutdown B-8
Drive Signal B-10
Drive Signal Alert Enable B-8
Dynamic Torque B-5
Edit Cycle Counts B-8
Edit Instrument Time B-5, B-8
Edit Travel Accumulator B-8
Effective Area (Acutator) B-5
End Point Pressure Control (EPPC) B-6
EPPC Deviation (Alert Setup) B-8
Fail Signal B-7
Feedback Connection B-7
Firmware Revision B-3
Flash Integrity Failure Shutdown B-8
Flow Direction B-5
Flow Tends to B-5
Function B-7
Hardware Revision (Device) B-3
HART Long Tag B-3, B-5
HART Tag B-3, B-5
HART Universal Revision B-3
Hi Cutoff Point B-6, B-8
HART Variable Assignments B-7
Inlet Pressure B-5
Input Characterization B-6, B-10
Instrument Alert Record B-8
Instrument Level B-3
Instrument Mode B-1, B-5
Instrument Serial Number B-3, B-5
Instrument Time is Approximate Enable B-8
Integral Enable B-6
Integral Gain B-6
Integrator Saturated High Enable B-8
Integrator Saturated Lo Enable B-8
Integrator Limit B-6
Intgegral Dead Zone B-6
Last AutoCal Status B-9
LCP Communication Failure Enable B-8
Leak Class (Trim) B-5
Length Units B-5
Lever Arm Length B-5
Lever Style B-5
Limit Switch Trip Point B-7
Limit Switch Valve Close B-5
Limit Switch Valve Open B-5
To Next Page
Loading...
