BATTERY REPLACEMENT
Battery replacement is simple with the ID Excel drop-in battery
compartments: just pop the doors open. Two 9-volt transistor
batteries are located in separate compartments at the rear of the
housing. When it’s time to replace the batteries, always replace
both of them.
1. To open the battery compartments, press gently
down and out on the battery door latch. The doors
are tethered; do not attempt to completely remove
them.
2. Tilt the housing gently and the batteries will slide
out.
3. Insert the new batteries. Make sure the contact
end goes in first and that you match the polarity
markings on the control housing.
13
To Next Page
Loading...
