8
FOR HIPMOUNTING
For almost effortless treasure hunting, the control housing is
easily removed from the handle and attached to a belt clip.
“Hipmounting” the IMPULSE in this manner takes half the
weight off the handle and allows the land or shallow-water
Treasure Hunter to search much longer without arm fatigue.
1. Grasp the handle grip firmly with one hand and the control
housing with the other.
2. Slide the control housing off the mounting bracket by pulling
it toward you.
3. Slide the belt clip into grooves on the bottom of the control
housing. This is a snug fit, and you’ll have to bend the belt clip
slightly.
4. Unwrap just enough of the coil cable to allow for searching.
5. Slip the control housing onto your belt, left side for right-
handers, right side for left-handers.
NOTE:
Because of the extreme sensitivity of the IMPULSE search coil,
hipmounting the control housing may produce a false signal
when the search coil reaches the end of its arc (on the side
that the control box is attached to your belt). Depending on
your stem length and how high you have the housing hip
mounted, the search coil may actually detect the housing.
You can hipmount your IMPULSE by sliding the control housing
off the handle and attaching it to your belt. This reduces the
weigth of the stem, creating nearly effortless hunting.
SETTING UP
To Next Page
Loading...
Need help?
General
