To Next PageTo Next PageWhat to do if Fisher PRO-CASTER unit stalls under load?
If the Fisher Spreader unit stalls under load, check the circuit pressure. The pressure should be 900-1200 PSI maximum, with the relief valve lifting at 1500 PSI.
Why does Fisher Spreader unit speed fluctuate when turned on?
If the Fisher Spreader unit speed fluctuates momentarily when the control is first turned ON, the oil may be cold. Wait until the oil has warmed up. Alternatively, change to a lighter weight oil.
What to do if Fisher PRO-CASTER Spreader pump blows seals at start up?
If the pump blows seals at start up, it may be because the pump was installed backwards. Replace the seals and reverse the pump in the driveline, noting the arrow on the pump.
General| Spread Width | 3-30 ft. |
|---|---|
| Mount Type | 3-point hitch |
| Hopper Capacity | 5 cu. ft. |
| Spreading Width | 3-30 ft. |
| Material Type | De-icing material, fertilizer, seed |
| Mounting Type | 3-point hitch |
Section to record spreader details and purchase information.
Explains hazard symbols (WARNING, CAUTION, NOTE).
General safety rules for operation and maintenance.
Information on electrical fuses and their replacement.
Guidelines for personal safety during work on the spreader.
Precautions for handling gasoline and preventing fires.
Advice on avoiding distractions while operating the vehicle.
Warning about exhaust fumes and need for ventilation.
Hazards and precautions related to battery use.
Airborne noise emission levels for the operator.
Table of recommended fastener torque values.
Importance of understanding labels on the spreader.
Vehicle certification requirements for spreader installation.
Table showing density of various spreading materials.
Diagrams of load capacities for different spreader sizes.
Specs for various spreader models (dimensions, weight, capacity).
Guide to calculate maximum vehicle material payload.
Worksheet for calculating vehicle payload.
Identification of cab control panel components.
General guidance on operating the spreader's engine.
Procedures for safely starting the spreader's engine.
Procedures for safely shutting down the spreader's engine.
Identification of dual cab control system components.
Instructions for using hydraulic spreader controls.
Steps for engaging and using the clutch on gas engines.
Steps to adjust engine choke for Tecumseh and Honda.
How baffle settings affect spread pattern and material flow.
Illustrations of spread patterns based on baffle settings.
Guidelines for greasing points and recommended lubricants.
Specifies the required gear oil for the spreader.
Procedures for checking and adjusting chain and belt tension.
Steps for maintaining the electric clutch.
Recommendations for engine maintenance and service.
Procedures for hydraulic system upkeep and fluid changes.
Common problems and their solutions for the spreader.
Step-by-step guide for removing the electric throttle motor.
Step-by-step guide for installing the electric throttle motor.
