It zeroes in on "extra crispy" high frequency tones, the realm of harmonics and
acoustic string sound. Lowering the Brilliance slider will reduce excessive fin-
ger noise and fret buzz.
XLR PRE / POST SWITCH
With this switch, you can choose between two signal paths for the XLR Output.
1) Post •
All controls on the Pro EQ Platinum affect the XLR output.
In the “Post” EQ position, you are in complete control of the sound going to
the PA or recording console. The Post EQ setting is especially useful in
venues where you want to control your volume and tone from the stage,
with little or no help from a sound-person.
2) Pre •
Only the Input Gain and Phase controls affect the XLR output.
Sometimes called a "direct" XLR signal. Set the switch to the "Pre" position
when you wish to give a sound-person complete control of the house sound.
It is often useful to send an additional post EQ signal from the ¼" output on
the Pro EQ Platinum to your stage amp or monitors, retain control of your
stage sound.
GROUND LIFT (XLR)
Use this switch to eliminate AC ground loop hum in the XLR output.
This type of hum often occurs when you're plugged into more than one AC
powered device. Note that unlike other manufacturer's DI/preamps, our ground
lift works even with phantom power applied at the XLR output.
9
9
Owner’s Manual
Owner’s Manual
To Next Page
Loading...
