14
USER MANUAL
VOLTAGE PARAMETERS
While best voltage is a preference that will vary from artist to artist, this machine has been tested
to operate at a minimum of 5 Volts and a maximum of 12 Volts. Depending on the type of needle
conguration or brand you use, feel free to adjust the voltage to obtain the desired performance.
ACCEPTED NEEDLES
Use only cartridge needles with an internal membrane. This will avoid accidental contamination
inside your machine. Fluids such as ink, water or oil will void warranty of the device and may require
replacement of internal parts.
MAINTENANCE
• The EXO is sold pre-lubricated from the factory and does not require internal lubrication.
• Prevent any type of external elements from entering inside the machine as they will disrupt the
motion of the component and contaminate the lubricant.
• The grip of the machine is autoclavable. Use only steam autoclaves at temperatures no higher
than 270° Fahrenheit or 132.222° Celsius. Add a hint of ointment or PTFE grease around internal
opening of grip or on stabilizing friction O-rings for optimal functionality after autoclaving. Refer
to page 5 for additional information.
• Machine Body and PowerBolt can be sanitized on the outside with cold sterilization products.
• Never spray the surface directly. Prevent fluids from entering the machine. Use no-lint rags or
paper towels.
• DO NOT DISASSEMBLE MACHINE.
WARRANTY
• All the housing components (Grip, Machine Body and PowerBolt) are covered by a
lifetime warranty.
• Internal parts are subject to wear and the motor itself is covered by a 1 year warranty from the
date of purchase.
• Motor warranty is void if motor shows signs of being dropped, of internal fluids entering the
motor and/or IF motor shows signs of being tampered with in any way.
ADDITIONAL INFORMATION
To Next Page
Loading...
