FläktGroup CET.ACEC - Set Modbus Address

Commissioning and testing CET.ACEC compact controller
22 FläktGroup DC-2017-0104-GB 2018-05/R1 • Subject to change
4.3 Set Modbus address
The Modbus address of the CET.ACEC compact controller can
be set with the five dip switches located at the bottom left of the
compact controller.
The position of the different dip switches determines the Mod-
bus address of the CET.ACEC compact controller.
It is not permissible to set the same address for two different
compact controllers if the are located in the same network.
Fig. 4-5: Position of the dip switches on the FläktGroup CET.ACEC compact controller.
Fig. 4-6
