Why are all the buttons flashing on my Flama 1256FL Coffee Maker?
The flashing of all buttons on the Flama Coffee Maker panel indicates that the water circuit needs cleaning. You should proceed with descaling as described in the chapter “Cleaning mineral residues/descaling“.
Why is no coffee coming out of my Flama Coffee Maker?
If no coffee is coming out of your Flama Coffee Maker, it may be due to a lack of water in the tank or the tank not being properly installed. Also, the machine may not have warmed up sufficiently. Make sure to fill the water tank, switch on the appliance, and allow it to heat up before brewing.
What to do if no steam comes out of my Flama 1256FL?
If no steam is coming out of your Flama Coffee Maker, the steam tube might be blocked, the steam selector may not be in the correct position, or the preheating process isn't complete. Clean the steam tube using a thin wire after each use. Ensure the steam selector is in the steam position and wait for preheating to finish.
Why is my Flama 1256FL Coffee Maker not frothing the milk well?
If your Flama Coffee Maker isn't frothing milk well, it could be due to unsuitable milk or activating the steam function too early. Use whole milk and only activate the steam function after the steam indicator light stops flashing.
Why is the coffee too smooth from my Flama 1256FL?
If the coffee from your Flama Coffee Maker is too smooth, the coffee may not be ground sufficiently or not pressed well enough. Try using a different type of ground coffee or using the doser/presser to press the coffee better.
What to do if the coffee buttons flash quickly on my Flama Coffee Maker?
The coffee buttons on your Flama Coffee Maker may flash quickly because the temperature rises significantly after using the steam function. Allow the machine to cool down.
General| Brand | Flama |
|---|---|
| Model | 1256FL |
| Category | Coffee Maker |
| Language | English |
To Next Page
