Flama 1256FL - Troubleshooting

23
English
TROUBLESHOOTING
PROBLEM PROBABLE CAUSE SOLUTION
No coee comes
out.
There is no water in the tank
or it is not installed. The
machine has not warmed
up.
Fill the water tank and switch on the
appliance.
It is necessary that the machine is hot
before brewing coee.
No steam comes
out.
The steam tube is blocked.
The steam selector is not in
the correct posion or the
preheang process is not
complete.
Use a thin wire to introduce through
the steam tube and clean the inside
aer each use.
Turn the steam selector to the steam
posion and wait for the preheang
process to complete.
The coee is too
smooth.
The coee is not ground
suciently or not pressed
well.
Use another type of ground coee or
the doser/presser to press the coee
beer.
Coee not
properly brewed.
Too much or too lile coee
in the lter.
1 coee requires 1 teaspoon of coee
and must be pressed well. The coee
should not be too ground or too thick.
Coarse ground coee is dicult to
extract and too ne ground coee will
aect the quanty and quality of the
coee.
The appliance is
not frothing the
milk well.
The milk used is not suitable
for this funcon. The steam
funcon was acvated
before the indicator
illuminated.
Use whole milk.
Steam can only be used when the
steam indicator light stops ashing.
The coee
buons ash
very quickly.
The temperature rises
signicantly aer using the
steam funcon.
Allow the machine to cool down.
All buons on
the panel ash.
Indicaon for cleaning the
water circuit.
Proceed as described in the chapter
“Cleaning mineral residues/descaling“