Why does Flama Coffee Maker drip tray collect too much water?
If the external drip tray of your Flama Coffee Maker collects too much water and the coffee comes out too slowly, it's likely that the coffee grind is too fine and is blocking the water outlet. Adjust the grinder to a coarser setting while it's operating.
What to do if Flama Coffee Maker buttons are not working?
If the buttons on the control panel of your Flama Coffee Maker are non-responsive, the appliance might be experiencing electromagnetic interference or the control panel could be dirty. Try unplugging the appliance, waiting two minutes, and then plugging it back in. Also, clean the control panel using the provided cloth.
Why no coffee comes out of my Flama Coffee Maker?
If your Flama Coffee Maker isn't producing coffee, it's possible that the vacuum system function was previously used. Press the hot water button until water comes out of the coffee spout.
Why does Flama Coffee Maker take so long to heat up?
If your Flama Coffee Maker takes too long to heat up, it's likely due to scale buildup. Descale the machine.
Why my Flama Coffee Maker coffee has no crema?
If the coffee from your Flama Coffee Maker lacks crema, the coffee beans may not be fresh. Try substituting with fresh beans or using a suitable brand.
How to make Flama Coffee Maker coffee hotter?
If the coffee from your Flama Coffee Maker isn't hot enough, it could be because the mugs haven't been pre-heated or the brewing group is too cold. Heat the mugs and perform manual cleaning of the appliance at least two times before preparing the coffee.
Why Flama Coffee Maker low bean light is on when full?
If the low coffee bean level indicator light turns on in your Flama Coffee Maker, even though there are beans in the container, the internal coffee grounds outlet might be blocked. Follow the steps in the “CLEANING THE GROUND COFFEE OUTLET” section.
Why Flama Coffee Maker touch buttons are not sensitive?
If the touch buttons on your Flama Coffee Maker are not sensitive, it might be because you're not pressing the most central area of the button. Ensure you press the button in its most central area.
What to do if Flama Coffee Maker internal drip tray cannot be placed?
If the internal drip tray and coffee grounds container of your Flama Coffee Maker cannot be placed in position and the machine is deactivated, it's likely they were removed during the brewing process. Place them back in the machine so it can detect them and continue the cycle. Afterward, remove and correctly replace them into position.
Why Flama Coffee Maker water tank alert doesn't work?
If the water level in your Flama Coffee Maker's water tank is very low when removing it, but the alert indicator didn't activate, the area surrounding the water tank connections might be damp. Clean the water surrounding these connections.
General| Brand | Flama |
|---|---|
| Model | 1293FL |
| Category | Coffee Maker |
| Language | English |
To Next Page
