- 14 -
Solid Wire
flux cored wire
Operation of LIFT TIG function
Please follow installation draft to install the TIG torch and earth clamp. In Lift TIG welding mode,
adjust
【
Current adjusting knob
】
The welding current can be changed. The welding current range
is 30A to maximum current 150A adjustment.
TIG welding function are for thin workpiece welding or stainless steel welding. Usually choose Ar
gas as protecting gas.
Connect the gas hose with gas tube on torch.
Connect the TIG torch on negative plug.
Connect the Earth cable on positive plug.
Fault display
：
OC light
When the welding load is overloaded and the output current of the machine is too large, the
internal temperature of the machine is too high, and the machine fault light will be on. This is
normal. The machine can recover after the heat dissipation becomes normal. Please restart the
power supply; When damaged, the fault light will be on, in this case, the machine is abnormal and
needs maintenance, please contact the supplier.
3.3 Polarity conversion joint
This machine has the polarity conversion; There are positive output terminal and negative output
To Next Page
Loading...