FLARING FM 155E - Table of Contents

To Next Page

To Previous Page

- 2 -

Version

Due to product version upgrades or other reasons, the contents of this document are not regularly

updated. Unless otherwise agreed, this document is intended as a guide only and all statements,

information and recommendations in this document do not constitute any guarantee, expressed or

implied.

The pictures in this document are for reference only. If the picture is different from the real one, then

prevail in kind.

Contents

.........................................................................................................................................

- 2 -

1 Product brief introduction

.........................................................................................................

- 3 -

1.1 Summarize.............................................................................................................................................. - 3 -

1.2 Technical parameters.............................................................................................................................- 4 -

1.3 Accessories list.................................................................................................................................... - 5 -

2 Installation instruction

...............................................................................................................

- 6 -

2.1 Welding wire Installation steps:............................................................................................................- 6 -

2.2 MIG Torch explosive chart.................................................................................................................... - 7 -

2.3 Gas shielded welding Installation........................................................................................................ - 8 -

2.4 TIG Torch explosive chart ................................................................................................................... - 8 -

3 operating instructions

.............................................................................................................

- 10 -

3.1 Operation panel interface................................................................................................................... - 10 -

3.2 Welding operation instruction.............................................................................................................- 11 -

3.3 Polarity conversion joint...................................................................................................................... - 14 -

3.4 Welding environment and safety....................................................................................................... - 15 -

3.5 Welding problems and solution......................................................................................................... - 16 -

4 Trouble shooting and error checking

.................................................................................

- 17 -

5 Daily maintenance and checking

.......................................................................................

- 20 -

6 Attention

.................................................................................................................................

- 23 -

7 Appendix

Ⅰ

Welding parameter list.................................................................................. - 29 -

8 Service GUARANTEE

.........................................................................................................

- 31 -