Flashforge Adventurer 5M Quick Start Guide

快速启动指南
中文P13
EN/CN - A03 Adventurer 5M / 冒险家5M
Quick Start Guide
1. Please refer to this Guide for initial printer setup.
2. Hot! Avoid touching the heating nozzle in operation.
3. Moving parts in the printer may cause injuries. Do not wear
gloves or other sources of entanglement in operation.
1. 请参照本指南完成打印机的初始准备。
2. 高温危险！打印机喷嘴在工作时会被加热，操作时请避免接触！
3. 可动部件可能会造成卷入挤压和切割伤害。操作机器时请不要
佩戴手套或缠绕物。
Do not power on the printer until installation is completed.
请勿在打印机安装完成之前通电。
安全提示
Safety Notice

Flashforge Adventurer 5M Specifications

General

Filament Diameter	1.75 mm
Nozzle Diameter	0.4 mm
Print Speed	600 mm/s
Layer Resolution	0.3 mm
Supported Materials	PLA, PETG, TPU
Connectivity	Wi-Fi, USB
Operating Voltage	AC 100-240V, 50/60Hz