Need help?Do you have a question about the Flashforge Guider 3 and is the answer not in the manual?
General safety advice for operation, electrical, and personal use.
Instructions on how to load filament into the 3D printer for printing.
Procedures for Z-Axis and Sensor calibration to ensure print accuracy.
Explanation of the main printing interface, including status and controls.
Replacing platforms and calibrating flatness for optimal prints.
Common user questions and their solutions for printer operation and troubleshooting.
General| Filament Diameter | 1.75 mm |
|---|---|
| Nozzle Diameter | 0.4 mm |
| Connectivity | USB, Wi-Fi, Ethernet |
| Supported Materials | PLA, ABS, PETG, TPU, etc. |
| Extruder Type | Single Extruder |
| Print Technology | FDM |
| Display | 4.3-inch touchscreen |
| Bed Temperature | Up to 120°C |
| Power Requirements | 100-240V, 50-60Hz |
| Machine Weight | 30 kg |
| Print Speed | 150 mm/s (Max) |
To Next Page
