Flashforge Guider 3 - First Printing; File Transfer Methods

4. First Printing
4.1 File Transfer: Wi-Fi Transfer
3. Software Installation
Method 1: Find the installation package of the FlashPrint software in the USB flash
drive and select the corresponding system version for installation.
Method 2: Download the latest slicing software installation package from our official
Chinese website [www.sz3dp.com] or our official English website
[www.flashforge.com] for installation.
Import the file to FlashPrint for slicing, select the printer type as Guider 3 to connect to
it [or by entering the IP address or by automatic scanning, while the IP address can be
viewed in the [About] of the equipment]. After completing slicing, send the file directly
to the printer for printing.
3D printing process：
Get the model file－Slice it with the slicing software - Transfer the file to the printer
for printing.
4.2 Printing From a USB Flash Drive
The equipment can also perform printing via a USB flash drive: save the sliced file to a
USB flash drive, insert the USB flash drive into the equipment, and select the
corresponding file to print.
12