Flashforge Guider 3 - Cloud Printing

1. Enter the FlashCloud website, register an account, and then log in after
completing email activation. FlashCloud website: https://cloud.sz3dp.com/
Enter the Polar Cloud website and register an account.
Polar Cloud website: https://Polar 3d.com
After logging in, click the avatar icon at the upper right corner, click [Settings], and
click the PIN Code in the menu to query the PIN code. After connecting Guider 3 to the
network, turn on the Polar Cloud switch and enter the account and PIN code.
2. Click the [My Printer] - [Add Printer].
Fill in the registration code [cloud registration code] on the "Add Printer" page, and
name the printer. After clicking the "OK", these information will appear on the
FlashCloud interface of the printer.
4.3 Cloud Printing
Print via FlashCloud
Print via Polar Cloud
13