Flashforge ADVENTURER 3 User Manual

Content
Preface
Notice
Terms
Components Introduce / Reference
Unpacking / Accessories / First Print
Load Filament / Communication / Model Print / Model Remove /
Replace filament / Interface Menus Introduction
06
07
28
31
01
Chapter 1:About ADVENTURER 3Chapter 1:About ADVENTURER 3Chapter 1:About ADVENTURER 3Chapter 1:About ADVENTURER 3Chapter 1:About ADVENTURER 3Chapter 1:About ADVENTURER 3
Chapter 2: ADVENTURER 3 OperatingChapter 2: ADVENTURER 3 OperatingChapter 2: ADVENTURER 3 OperatingChapter 2: ADVENTURER 3 OperatingChapter 2: ADVENTURER 3 OperatingChapter 2: ADVENTURER 3 Operating
Chapter 3: Q&AChapter 3: Q&AChapter 3: Q&AChapter 3: Q&AChapter 3: Q&AChapter 3: Q&A
Chapter 4: Supports and ServiceChapter 4: Supports and ServiceChapter 4: Supports and ServiceChapter 4: Supports and ServiceChapter 4: Supports and ServiceChapter 4: Supports and Service

Flashforge ADVENTURER 3 Specifications

General

Build Volume	150 x 150 x 150 mm
Layer Resolution	0.1 - 0.4 mm
Nozzle Diameter	0.4 mm
Filament Diameter	1.75 mm
Connectivity	USB, Wi-Fi
Extruder Type	Single
Touchscreen	Yes
Heated Bed	Yes
Technology	FDM
Software	FlashPrint
Dimensions	388 x 340 x 405 mm
Supported Materials	PLA, ABS
File Format	STL, OBJ
Weight	9 kg
Display	2.8-inch color touchscreen
Power Requirements	100-240V, 50-60Hz