Flashforge ADVENTURER 3 - Replace Filament

Extruder heating on...
Replace filament
1
.
Tap [Filament]--Tap [Replace], extruder will start preheating.
2
.
Pull out the filament as the picture
showed above.
4
.
When new filament come out of extruder steadily, replace is completed, Tap [OK].
3
.
Insert new filament into the filament intake
and push the filament into the feeding wheel
until resistance is sensed.
Load
Replace
200
/220℃
Cancel
220
/220℃
220
/220℃
OK
220
/220℃
OK
16
Unloading the filament,
please wait...
Pull out old filament, insert
new filament, tap [ok] button.
When filament load the extruder
steadily, replace completed.