4
Personal Safety
• Do not touch the extruder, build plate, etc., during printing.
• Do not touch the extruder and build plate after finishing printing to avoid high
temperature burns or mechanical damage.
• Do not wear scarves, masks, gloves, jewelry, or other objects that can easily get
tangled into the equipment while operating it.
• Do not operate the equipment while you are tired or under the influence of
drugs, alcohol, or medication.
Cautions
• Keep the inside of the equipment clean. Do not drop metal objects into the
grooves at the bottom of the build plate.
• Please clean up filament debris in time. It is recommended to operate this
outside the equipment.
• Any modification of the equipment by yourself will void the warranty.
• Please keep the distance between the extruder and build plate for at least 50mm
during filament loading. Too-close distance may cause nozzle clogs.
• Please operate the equipment in a well-ventilated environment.
• Do not use the equipment for illegal activities.
• Do not use the equipment to make food storage containers.
• Do not place printed models into your mouth.
Equipment Environment Requirements
Room temperature: 15-30℃; Humidity: 20-70RH%
Equipment Placement Requirements
The equipment must be placed in a dry and well-ventilated environment. A distance of
at least 20cm must be reserved around the front, back, left, and right sides of the
equipment. Recommended storage temperature: 0-40°C.
Compatible Filament Requirements
When using this equipment, it's recommended to use Flashforge's filaments. If non-
Flashforge filaments are used, there will be certain differences in material properties,
and print parameters may need adjustments.
Filament Storage Requirements
Please store filaments in a dry and dust-free environment after unpacking. It is
recommended to use the matching filament dry box for storage.
To Next Page
Loading...
