To Next PageTo Next Page
Need help?Do you have a question about the Flavel Calypso FNCN**SN Series and is the answer not in the manual?
General| Type | Gas Fire |
|---|---|
| Ignition Type | Piezo |
| Control Type | Manual |
| Fuel Type | Natural Gas |
| Flame Picture | Realistic |
Details specific model numbers for Natural Gas and Propane, and trim notation.
Covers legal requirements, shelf clearances, ventilation, flue sweeping, wall covering effects, and battery notes.
Highlights naked flame risks, fireguard use, annual servicing, spillage tests, fuel bed care, and keeping combustibles clear.
Step-by-step guide for lighting the fire using the control knob and igniter.
Procedure for lighting the pilot flame using a taper if the igniter fails.
Important safety note regarding a 3-minute cooling period before relighting.
Step-by-step guide for lighting using the control lever and ignition sequence.
Procedure for lighting the pilot flame using a taper if the igniter fails.
Important safety note regarding a 3-minute cooling period before relighting.
Procedure for lighting the fire using the remote control handset buttons.
How to adjust heat levels up or down using the small and large flame buttons.
Instructions for entering standby mode and completely switching off the appliance.
How to turn off the fire using the emergency shut-off switch on the control panel.
Procedure for replacing batteries in remote control models, emphasizing alkaline type.
Procedure for replacing batteries in slide control models, emphasizing alkaline type.
How the spillage monitoring system shuts down the fire if the flue is blocked.
Methods for cleaning fire trims and painted metal components using damp cloths.
Instructions not to clean fuel bed components; replacing damaged parts via dealer.
Placing the ribbed ceramic fuelbed base onto the support and ensuring correct fit.
Placing the two halves of the front ceramic onto the locating channel.
Fitting five large coals evenly spaced on the front ceramic rail.
Placing four large coals behind the front row and one small coal at each end of the second row.
Placing five large coals along the rear of the fuelbed using ribs as a guide.
Positioning remaining four large coals to fill gaps in the third row.
How to remove and refit the trim on Rhapsody and Calypso models.
How to remove and refit the trim on Richmond models using magnets.
How to remove and refit the trim on Caress models using brackets.
List of part numbers for user-replaceable fuelbed base, front rails, and coal sets.
