4.12.4 Re-assemble in reverse order and carry out a gas tightness test. Re-fit
coals as shown in section 3. The fender and ash pan cover or fascia
can now be re-positioned.
4.13 Replacing the Batteries (Within the Firebox)
4.13.1 Remove the fender and ashpan assembly The battery holder is located
on the valve at the right hand side of the burner.
4.13.2 Remove the battery cover.
4.13.3 Replace in reverse order and check correct operation of the appliance.
NB The handset uses two off AA batteries and should be replaced by
removing the cover on the rear of the handset.
ENSURE THE BATTERIES ARE CONNECTED TO THE CORRECT POLARITY
POSITVE (+), NEGATIVE (-)
4.14 Removing the Trim Switch
4.14.1 Remove the burner assembly as in section 4.10 and disconnect the trim
switch cable from the control board.
4.14.2 Remove the trim switch from the mounting frame (held in position by
self adhesive backing).
4.14.3 Re-connect to the wiring loom.
4.14.4 Replace in reverse order and carry out a gas tightness test.
45
To Next Page
Loading...
Need help?
General
